- “10PCS 2W 2.2 Ohm High Power Resistors” already exists in your wishlist
-
1.2V NI-MH GP ReCyko+ 1000mAh Rechargeable AA Batteries – Reliable & Eco-Friendly Power Solution
-
Brand: GP Batteries
-
Model: ReCyko+ AA 1000mAh
-
Battery Type: NiMH (Nickel-Metal Hydride)
-
Capacity: 1000mAh
-
Voltage: 1.2V
-
Recharge Cycles: Up to 1000 times
-
Shelf Life: Retains charge for up to 12 months
₨ 110 -
-
D1047 – High Power NPN Transistor | 140V, 12A, 100W
-
Voltage Rating (Vce): 140V
-
Collector Current (Ic): 12A
-
Power Dissipation (Pd): 100W
-
Package Type: TO-3P
-
Gain (hFE): 40 – 320 (Typical Range)
-
Applications: Audio Amplifiers, Power Switching Circuits, Motor Control, Voltage Regulators
-
High Efficiency and Durability
-
Reliable Performance in High Power Applications
₨ 110 -
-
3.7V AA Lithium-Ion Rechargeable Batteries – 450mAh | Reliable Power for Electronics
-
🔋 Voltage: 3.7V (Higher than standard AA for enhanced performance)
-
🔁 Rechargeable: Yes – Recharge hundreds of times, saving money
-
⚡ Capacity: 450mAh – Suitable for low to medium drain devices
-
📐 Standard Size: AA – Compatible with most AA-sized battery compartments
-
🔧 Battery Type: Lithium-Ion (Li-ion) – Lightweight, efficient, and powerful
-
🌍 Eco-Friendly: Helps reduce waste and environmental impact
-
🧰 Best For: Flashlights, toys, remote controls, Arduino/DIY projects, portable devices
-
🛡️ Reliable Quality: From Shehzad Electronics – Trusted seller with 4+ years of experience
₨ 110 -
-
5V 2A Dual USB Power Bank Module – DIY Charging Board
-
🔌 Dual USB Output Ports – Charge two devices at once with 5V 2A total output
-
🔋 Battery Compatibility – Supports 3.7V lithium-ion and polymer batteries (including 18650 cells)
-
🛡️ Safety Protection Built-In – Overcharge, over-discharge, short-circuit, and overcurrent protection
-
⚙️ Compact Design – Easy to install in custom enclosures or DIY power bank cases
-
💡 Low Power Consumption – Efficient design for long battery life
-
📏 Approximate Size – 68mm × 30mm × 12mm
-
🔧 User-Friendly Setup – No soldering required for basic installation
₨ 110 -
-
2S 3A BMS Li-ion Lithium Battery 7.4v 8.4V 18650 Charger Protection Board
✅ Supports 2S (7.4V) Li-ion / Li-Po Battery Packs
✅ Overcharge Protection: 4.25V – 4.35V ±0.05V
✅ Over-Discharge Protection: 2.3V – 3.0V ±0.05V
✅ Continuous Current: 3A | Peak Current: 5A
✅ Short-Circuit Protection: Auto Recovery Supported
✅ Ultra-Low Standby Current: <3µA for Long Life
✅ MOSFET Controlled Charging & Discharging
✅ Compact Design, Easy to Install
✅ Operating Temp: -40°C to +50°C₨ 110 -
3.7V 220mAh Lithium-Ion Rechargeable Battery
⚡ 220mAh Reliable Capacity
Perfect balance of compact size and dependable power output.🔋 Stable 3.7V Performance
Ensures smooth operation for sensitive electronic circuits.🛡️ Built-In Protection Board
Protects against over-charging, over-discharging & short-circuit.📏 Ultra-Compact Dimensions
Size: 2.5 × 1.5 × 0.8 cm — fits where others can’t.🪶 Super Lightweight
Only 4.4g, ideal for wearable and portable gadgets.🔁 Rechargeable & Long Life
Designed for multiple charge cycles with consistent performance.🔌 Pre-Wired Leads
Quick and easy installation for DIY & repair work.₨ 110 -
PRO-SERIES 200W D1047 STEREO AMPLIFIER PCB
-
🔊 Dual-Channel Stereo: Complete Left and Right channel amplification on a single, high-quality board.
-
💎 Quad D1047 Power: Utilizes four D1047 NPN transistors for a balanced and punchy output.
-
⚡ 200W Total Power: Delivers 100W per channel, perfect for 8-inch to 10-inch home speakers.
-
📏 Extended PCB Design: Large 14.6cm x 8cm layout provides better airflow and easier soldering.
-
🛠️ Error-Proof Assembly: All component values are printed directly on the board for a “no-manual” assembly experience.
-
🌡️ Integrated Heat Management: Linear transistor alignment allows for direct mounting to a single aluminum heat sink.
-
🔋 Efficient Voltage Range: Optimized for 25V-0-25V AC input, making it compatible with standard 5A-7A transformers.
-
🛡️ Built-in Power Section: Features dedicated slots for large filter capacitors ($4700\mu F$ or higher) for hum-free audio.
-
🔌 Versatile Connectivity: Separate pads for Ground (GND), Speaker Out (SP), and Audio Input (IN) for clean wiring.
₨ 110 -
-
KY-022 IR Sensor Receiver Module – Smart Infrared Detection Solution
🔴 High Sensitivity Infrared Receiver
🟠 Fast Signal Detection & Response
🟡 Compatible with Most IR Remote Controls
🟢 Works with Arduino, ESP32 & Raspberry Pi
🔵 Compact & Lightweight PCB Design
🟣 Easy 3-Pin Interface Connection
⚫ Stable & Reliable Performance
🟤 Low Power Consumption
🔴 Built-in Indicator LED
🟠 Perfect for DIY & Automation Projects₨ 110 -
22mm Diameter, 1 Meter Length (Black) High-Quality Heat Shrink Tube
-
Length: 1 meter
-
Diameter: 22mm
-
Color: Black
-
Material: Flame-retardant, flexible, and durable.
₨ 112 -
-
Dual USB Power Bank Module 5V 2A – Reliable Charging Circuit
-
🔌 Dual USB Output Ports – Charge two devices simultaneously with a total 5V/2A output
-
🔋 Battery Compatibility – Works with 3.7V lithium-ion and polymer batteries (18650, flat cells, etc.)
-
💡 LED Battery Level Indicator – 4-stage display shows real-time battery charge status
-
🛡️ Built-in Protection Circuitry – Prevents overcharge, over-discharge, over-current, and short-circuit
-
⚙️ Compact PCB Design – Easy to fit into custom cases or enclosures (Approx. 68×30×12mm)
-
🧠 Auto Power-Off Feature – Shuts down intelligently when not in use
-
🧰 Plug-and-Play Setup – No soldering required; quick battery terminal connection
-
🔧 Perfect for DIY & Learning – Ideal for electronics students, makers, and repair professionals
₨ 115 -
-
HWY-800 Liquid Soldering Flux 15ml/25ml | Stainless Steel Welding Flux | Non-Toxic Quick Solder Tool
⚡ Quick & Easy Welding – Speeds up soldering process
🔩 Works on Difficult Metals – Stainless steel, nickel, iron & more
💧 Liquid Formula – Better absorption and even distribution
🛠 Strong Bonding Power – Creates firm and reliable joints
🌿 Non-Toxic & Eco-Friendly – Safe to use
🔥 Improves Solder Flow – Smooth and clean soldering
🚫 No Corrosion – Protects metal surfaces
🎯 Professional Performance – Ideal for repair shops & DIY users
🔄 Multi-Purpose Use – Electronics, automotive & heavy-duty tasks
⚠️ Not Suitable for Aluminum₨ 120 – ₨ 170
